Setup sheet question?

[av4625]

in this setup sheet adam wrote his pistons where 1.3 by 6 drilled, drilled to wat?

http://www.team-durango.com/pdf/setups/TD102007/Coventry_GB/DEX408_MAM_Round%205_Adam_Skelding_26_03_2012.pdf

[rsj]

Each piston has 6 holes of 1.3mm

[tomvanelsen]

Those are the pistons you have to use in the front according to the manual, it also says it on the piston itself: TD1.3x6mm.
I used them in the front and rear, because the rear was a bit stiff for my track

[av4625]

do they come blank or what in the dex408 because i no u can get the 1.3 by 6 hole but his says drilled i thought he drilled those pistons bigger or something

[Alan Reeves]

post in error

[tomvanelsen]

What car are you actually talking about? But if you want to know which pistons come with the 408 just check the manual on their website

[graveltrap]

There is a different behavior between a drilled and molded piston hole...A drilled hole will offer slightly more pack.

Start with a smaller hole sized piston then open it up to the required size with yes you guessed it a drill ;)

[av4625]

i run a dnx408 but was just looking at shock setups for dex408