BGP Foam inset Minispike

[Christer Rasmussen]

In general what insert would you use for the rear tyre.
Normal or Tubby insert.

If I go for the Schumacher insert, I think about Medium U6734 or Medium Tubby U6747.
I don't want to test 5 brands and 5 compounds.

[bzb]

im not in a state to anwser decent to any danish :D and german :thumbdown:

(notting personal ;) )

[feniks]

most drivers over here run the MRO inserts.
for the 2 wd they run the chubby in the rear .
for the 4wd they run the extra wide soft in the rear and the front depends on the driver and the car . but most go also front soft extra wide .
and for the rain we always go chubby for the silvertyers front and rear . but than they are cut inside and outside to create more drive and sitebite .
hope this helps .
as I now you now nathan aswell contact him and he will get you les (mro) his contact info.
greets and best regards Bart

[janus_77]

Here are a couple of setups to check-out

http://www.rc-offroad.be/setup.htm

I personally mostly use Answer-RC 45mm Rear Medium, and use 2mm of cel-foam on the rim to make them a but stiffer.

[flipside]

Hey Christer, I would also just use tubbie MrO inserts. I don't use anything else in minispikes :)

I chamfer them inside and outside, but that is more to prevent the glue from touching the insert, they fit better in the tyre when mounting.

[beksie]

Nog een band insert vraag. Ik kwam low profile cut staggerds (silver) tegen. Ik heb maar een setje besteld voor het geval het regent met de GP.
Maar ze voelen wel heeeeel erg snotterig aan. Ik zou denken dat hier wel een insert in moet.
Is dat zo?? Iemand ze al geprobeerd?