X11 Rocker Crank Pivots

[pesky badger]

Hi all

Did first race today with the X11 - broke in second qualifier :mad:

The cheese like rocker crank pivit sheared and so needs replacing. I recall reading somewhere that the X10 version is more substantial, but Team Exteme's site shows two versions for the non-X11 versions. Which is the one to use and do I need anything else to make it fit?

[Garry Driffill]

Hi mate,

Im currently using the X10 ones these are a direct fit all you need is the little nut to fit on the top to hold the rocker on obviously and not the button screw. Im sure there will be some new ones that arent hollow in production soon enough.

This is what you need:

http://i211.photobucket.com/albums/bb274/xx4-nutter/S110A.jpg
ROCKER CRANK PIVOT SHAFT FRONT (X2)
£8.50
Model: S110A

And...

M3 NYLOC NUT (X10)
£2.55
Model: XH007

Garry

[pesky badger]

Moo charse, grassy ahrse :thumbsup:

[mattym0310]

hi! do you have the Lunsford turnbuckles for the upper wishbones yet? or do you have the standard kit ones still? if you don't have them yet drop me a PM :)

[Tom3012]

Hi mate,

Im sure there will be some new ones that arent hollow in production soon enough.


Garry

as we speak garry, my dad spoke to lewis and there is some being made/finished :D

[pesky badger]

in answer to Matty - yes I have the new titanium turnbuckles. :lol:

In response to Tom -unfortunately I need them for next Sunday (mid south regional). :eh?:

[mattym0310]

gld you have em. Give the shop a call tomorrow and you will have them in a couple of days, if not then order off the site or even send Yanina an email. Hope you get em sorted! :)

[Garry Driffill]

as we speak garry, my dad spoke to lewis and there is some being made/finished :D

LOL, thats ace news :D. Cheers Tom :D

[Chequered Flag Racing]

Hi all

Did first race today with the X11 - broke in second qualifier :mad:

The cheese like rocker crank pivit sheared and so needs replacing. I recall reading somewhere that the X10 version is more substantial, but Team Exteme's site shows two versions for the non-X11 versions. Which is the one to use and do I need anything else to make it fit?

http://www.oople.com/forums/images/icons/icon3.gif Run a longer m3 screw through the pivot so it just shows @ the bottom if you can't get hold of the X10 part. It will then fill the void in the pivot and give more support.http://www.oople.com/forums/images/icons/icon14.gif

not saying it won't break though http://www.oople.com/forums/images/icons/icon10.gif

[pesky badger]

I've managed to get hold of some X10 ones now, so should be ok. :thumbsup:

[mattym0310]

http://www.oople.com/forums/images/icons/icon3.gif Run a longer m3 screw through the pivot so it just shows @ the bottom if you can't get hold of the X10 part. It will then fill the void in the pivot and give more support.http://www.oople.com/forums/images/icons/icon14.gif

not saying it won't break though http://www.oople.com/forums/images/icons/icon10.gif

i don't think you can actually do this as the thread isn't cut right through the pivot. It's only in the top half ;)

[Tom3012]

i tried putting a longer screw through and it simply doesnt fit if its any more than like 2mm longer than the original screw :(