LRP SXX V2

[reg]

Hi,iv got my LRP back from repair,it wont let me calibrate it to the handset,i get 3 flashing lights,when i hold down the set button to go into calibrate nothing happens,
when i do the same thing on my old 2007 sphere,in the same car,it will let me do it as and when i want,
any ideas
thanks

[RudolfXC]

Have a look in the manual for error codes as you may have a faulty sensor wire, low Voltage, etc?

[Timee80]

Sorry to state the obvious but check that the receiver wire is plugged in the receiver properly. It will do what you say if it isn't

[reg]

thanks chaps,iv had a look and its plugged in ok,
i had a look at error codes,it does show the error you say,but im doing it on a brushed setup,
if i plug it into a 1s battery it will show the blue light an a green,this is before i press anything,

[RudolfXC]

You can't use the ESC on a brushed motor so it is probably showing a short.

[morpheus2010]

Take a look at the Manual LRP SXX V2 Manual(PDF) (http://www.lrp.cc/fileadmin/lrp_anleitungen/anl_28490_ra00292-sxx-serie-vers.2-e-100519fv.pdf)

Pure "BRUSHLESS" won't work with brushed motor :blush:

The LRP Sphere will support brushed motors but NOT the SXX

[reg]

:woot:

[Hpi_guy]

i have a novak gtb mark that will work with brushed, i would be willing to swap or sell

[reg]

Its fine thanks,its for my buggy,i was just testing it in my ss and that had a silvercan in

[Hpi_guy]

fair enough, you need to come down to a1 again mark

[reg]

Thanks for all the help chaps,fitted a brushless motor and its all good :woot: