Sanwa 451 aerial repair

[mikeyscott]

I've found my sanwa 451 reciever aerial broken and it's broken near the case, so prob about 3 - 4cm on the wire.

So two questions:

1) How much of an issue is this going to be on a 1/10th track?
2) Any suggestions for who can repair these RXs?

Mike

[paulc]

If it's just the aerial just replace it open the case there not soldered in just clips on to the board aerials only about £5

[mikeyscott]

If it's just the aerial just replace it open the case there not soldered in just clips on to the board aerials only about £5

Ah ok, cheers I'll have to find out who sells them and hope I can get one for the TORCH GP.

[paulc]

This
http://www.modelsport.co.uk/hpi-2.4ghz-receiver-antenna-300mm/rc-car-products/36801

or this should do the job http://demonpowerproducts.co.uk/product_info.php/zeppin-24ant-24ghz-receiver-aerial-short-10cm-futaba-sanwa-p-6473

I have the Zeppin one works fine

[mikeyscott]

This
http://www.modelsport.co.uk/hpi-2.4ghz-receiver-antenna-300mm/rc-car-products/36801

or this should do the job http://demonpowerproducts.co.uk/product_info.php/zeppin-24ant-24ghz-receiver-aerial-short-10cm-futaba-sanwa-p-6473

I have the Zeppin one works fine

Cheers,

Also found this - http://www.apexmodels.com/gbu0-prodshow/SAN107A41101A.html

Will contact shops on Monday.

Mike