Who sells machined big bore pistons?

[samd]

Who sells big bore machined pistons?

Any opinions on no holes and sizes? I see from the
setups people seem to now be running 2x1.7 front 3x1.7 rear.

Sam

[jo90]

one word - Tresrey. they do a pack of 4 blank (though with small marks on the piston for drilling) MOS coated big bore piston blanks.

Brilliant stuff

also someone i know is selling 1.7mmHSS drill bits to on here hehe ;)

[cornishboy176]

PM Gixxer on here

[Allan1875]

Did you get these mate? Don't trust myself to drill my own blanks in the kit and don't want to use the 6x1.2 the v3 cones with.

[TonyM]

I find the TD tapered pistons are great as long as you want 4, 5 or 6 holes. They come ready drilled with the smallest hole 1mm, so very easy to ream/drill out to whatever size you wish.

At a push, if you want 2, or 3 holes you can just close extra holes with a soldering iron.

[Allan1875]

I find the TD tapered pistons are great as long as you want 4, 5 or 6 holes. They come ready drilled with the smallest hole 1mm, so very easy to ream/drill out to whatever size you wish.

At a push, if you want 2, or 3 holes you can just close extra holes with a soldering iron.

Where do you pick these up mate?

[TonyM]

Where do you pick these up mate?
Either directly of Durango's website, or shops like MB Models. The part numbers are:-

Single Taper
TD330178 4 hole
TD330179 5 hole
TD330180 6 hole
Dual Taper
TD330394 4 hole
TD330395 5 hole
TD330396 6 hole

As I mentioned, they are all 1mm holes.

[Allan1875]

Either directly of Durango's website, or shops like MB Models. The part numbers are:-

Single Taper
TD330178 4 hole
TD330179 5 hole
TD330180 6 hole
Dual Taper
TD330394 4 hole
TD330395 5 hole
TD330396 6 hole

As I mentioned, they are all 1mm holes.

Thanks bud.

[Allan1875]

Either directly of Durango's website, or shops like MB Models. The part numbers are:-

Single Taper
TD330178 4 hole
TD330179 5 hole
TD330180 6 hole
Dual Taper
TD330394 4 hole
TD330395 5 hole
TD330396 6 hole

As I mentioned, they are all 1mm holes.

Thanks mate.

If you want other options suchs as 1.7mm etc, do you just have to drill your own?