Northy's Southport set-up

[Northy]

A couple of people asked for my set-up at Southport because they said the car look very planted, so here it is:

front

springs blue (no compreision spring) 5 1/2 turn in older style
oil 30wt losi
piston kit (1 hole 1 groove) with hole drilled out to Losi Orange and with standard rebound valve
rocker mounted upside down
pushrod under rocker
droop 37mm
std front arms with 0 washer behind wishbone
cone washer replaced with 2 x 1mm washers
no roll bar
ride height 18 mm (driveshafts just below level)
front wing cut so it is as large as possible
0 toe out
-1 degree camber

rear

springs blue and compresion spring 5 1/2 turn in older style
oil 37.5 losi
piston kit (1 hole 1 groove) with hole drilled out to Losi Orange
lower hole on shock mount
no roll bar
std wheelbase
ride height 24mm
1.5mm rear block (reduces on power steering)
large rear wing with full gurney
3 degree toe in per side
-1 degrees of camber
rear uprite in upper hole

shumacher yellow minispikes with outside row cut off rear and inner and outer cut off front

5.5R nosram 14mm sintered rotor
18/72
nosram istc
speedo settings 2/2/2/2.

[niggs98]

how do you get away with not using the roll bar as i tend to use it everywhere or does it just smooth the car out even more then with the roll bar

[Northy]

I've just never really used roll bars Nath :woot:

G

[jeff jenkins]

its pretty funny i tried the big front wing like you have northy at my tophy race i had last weekend during practice and it got really windy for a litttle bit during one of my practice run and it felt like my car wanted to fly off of the jumps because the wind caused it to feel like it was floating...haha
it was the wierdest thing.. but when it wasnt windy the car felt good with it on.. but i took it off as i needed more rear traction than front. :D