Log in

View Full Version : Tresrey rear hanger causing lots of slop!

Joshyjol
29-05-2013, 09:44 PM
So im fitting a new Tresrey RR hanger on the 210 and I notice there is loads of slop in the rear bottom wish bones after doing so.

So i have a look and notice the holes are much larger than the stock one and dont allow the hinge pins to sit snug but rather quite loose. (see pic for size difference)

Does anyone have any solutions? Do I need to be using some inserts of some sort or am I just missing a trick somewhere!

Please help, TA!
graveltrap
29-05-2013, 10:12 PM
You will need some pivot balls.

http://www.team-durango.com/part-info.php?partNo=TD330037
Joshyjol
29-05-2013, 10:18 PM
You will need some pivot balls.

http://www.team-durango.com/part-info.php?partNo=TD330037

They kept that quiet in the advertising!

Thank you very much good sir!
Cream
29-05-2013, 10:29 PM
They kept that quiet in the advertising!

Thank you very much good sir!


That's because the Tresrey rear hanger was out before the RTR kit. The original kit comes with the pivot balls. ;)
jo90
30-05-2013, 12:06 PM
confirm that, I run this hanger on my 210 never had an issue. I do add though a 0.5mm washer on the suspension pivot arm just to take the front to rear slop from the wishbones, it just takes it up enough that there is a little, but not 1mm worth that there was.
mattr
30-05-2013, 01:30 PM
confirm that, I run this hanger on my 210 never had an issue. I do add though a 0.5mm washer on the suspension pivot arm just to take the front to rear slop from the wishbones, it just takes it up enough that there is a little, but not 1mm worth that there was.I think the instruction book actually has an extra spacer in there anyway. (possibly)
jo90
31-05-2013, 07:05 AM
Actually it only remarks on 2 1mm spacers either side. Maybe being the plastic in the kit they fit a little tighter in the space, and when you use alloy ones the slack is more noticable. In the end I have the tresrey spacers either side, oplus a snigle 0.5mm shim in there too
Danosborne6661
31-05-2013, 08:09 AM
I bet you had loads of slop without the pivot balls :lol:
Joshyjol
31-05-2013, 11:40 AM
A whole lot indeed! haha

Got some pivot balls on the way, was hoping they would be here today but royal fail struck again!
jo90
31-05-2013, 11:59 AM
I've just taken a look and I believe the RTR comes with the +8mm chassis. If it does you will also need a small spacer as well as the kit spacers either side of the wishbone. If you have some .5mm they should be ok. I think it's due to the hole being drilled a tad further apart