Speed Passion Problems.....

[Callum]

Hi chaps,
I have yet another problem with my Speed Passion Reventon Pro im running it with a GM motor.:thumbdown:
I was racing at a regional and it was running faultless all day until I switched it on for the final the problem is that when its first switched on it pulls away fine but as soon as you use the brakes to come to a complete standstill and pull away again it wont I just get loads of flashing lights on the speedo.
I have tried it with no cut off protection and heat protection disabled but still get the issue, the motor cogs really bad and the same problem occurs in sensored and senorless modes.
Also after landing of a jump it just cut out.
I have also tried fitting a new capacitor.
The problem was intermittent to start with it and would only do it occasionally but it does it everytime now without fail.
Also all the solder joints are good.
Any ideas?
Cheers Callum

[OneKiwi]

Sensor lead or sensor board in either the motor or esc, probably in the esc as you said you tested it in sensorless mode.

Will probably be a return for fix/replacement job

[Callum]

Ok thanks will have to see what they can do, already had problems with it before and was going to send it back then it was fine again, this will be the third time its played up....
Cheers Callum

[Pitman Ed]

Sounds like a bad connection somewhere in the system. Check all wiring and plugs etc. It could be the same fault but inside ESC.

[Callum]

Oh I forgot to mention if you turn it off and then on again it will be fine until you brake.

[Callum]

Just to let you know tried a mates motor and it works fine, turnigy trackstar 7.5t on the way:):)