DEX408 rear hubs

[4nd7]

Looking at the rear hubs i just want to be clear on something. One set are unmarked and the other is labelled L/1 and R/1.

Does this /1 refer to +1mm track width or +/- 1 degree? Only reason for the confusion is because i can't see any added pin angle despite being referred to as 1 degree hubs but i can measure a 1mm pin off set towards the inside of the hub!!

[Jason A]

Hi,

The hubs that are unmarked are standard hubs and the ones that have L1 and R1 on are +1 degree hubs.

:thumbsup:

[4nd7]

Thanks. So standard hub on standard blocks is 3 degree toe and the plus 1 hubs will give you a total of 4 degrees! Is there any way to adjust inboard toe to say 2.5 /3.5 ?

[Jason A]

Hi,

If you are wanting more than just the kit 3deg and 4deg then you would have to order the optional toe in and kick up inserts

Part #: TD330303 (http://www.team-durango.com/part-info.php?partNo=TD330303)

:thumbsup: