Associated Hex Rear Wheels on BMax2 MR

[neiloliver]

What are peoples experiences with using Associated rear wheels on the BMAX2?

I assume that if the Associated hexs' are used then some shims will be required to stop the movement of the driveshaft in the hub?

Thank you
Neil

[mes]

There are several possibilities, I am using BM-011S wheel spacers and proline B4 rear hexes. SC10 adapters are also supposed to work, but I didn't try it so far.

[neiloliver]

Thanks. Are the proline adaptors these:

http://prolineracing.com/performance-parts/aluminum-12mm-rear-clamping-hex-adapters/

?

If so, I wonder if they are the same thickness as the Associated ones?

[mes]

Yes, these are the ones. Thickness should be the same.

[neiloliver]

OK, thanks. I just tried the Associated wheel spacers off my B4, they fit most of the way onto the shaft but fail to go the last ~3mm as the shaft increases in diameter by a very very small amount. I will get the spacers you suggest (off the BMAX4 ?) and give them a try with my Associated wheel hex adapters.

The car is now all ready to go, I just need my new shell.

Neil

[mekios]

I am using b4 front hexes over the stock conical spacer. It's really easy and the offset is the same.