Atomy b44 - servo + receiver mounting

[Medders]

Can anyone recommend posts to use to mount the servo?

Am I correct in assuming most people would put the receiver on its side next to the servo :confused:?

[ben]

Yeh put the receiver on its side. Erm not sure on servo posts. Maybe use losi xx4 mounts?

[Chris Doughty]

I think the posts that are used are the AE RC10 GT servo mount posts, but they are cut down a little

[Medders]

I think the posts that are used are the AE RC10 GT servo mount posts, but they are cut down a little


those look like ones for mounting servo horizontally :confused:

[Garry Driffill]

Ive got Losi ones on my S4 and they seem ok. Cant imagine much difference to the Atominized B44 ones..

You can use B4 ones if you were to lay the servo down too, Plus doing this will give you extra room for say mounting the recevier onto

[GRIFF55]

i use long screws with nuts on, worked a treat all season!

[Pedros20]

Speaking of servo's, i've just bought an Atomised B44, but i've been told i can only run a low profile servo? is this true? if so, can anyone recommend one?
Does the Associated xp 1015 fit?
Cheers

[Chris Doughty]

I run the AE XP1015 no problem.

you can run a short servo if you like, but I like the full sized AE ones

[Pedros20]

Cheers Chris.
I'll do the same.:thumbsup: