Advice needed on frsky receiver setup

[Dazzle]

Hi. As title really. Ive just ordered a hack module and a D4R-II receiver. However looking at the pictures, the pin layout is different to how a standard receiver would look. So my question is, does a standard servo plug just push onto the pins (receiver pins look too wide) or do I need special plugs to wire onto my servos?? Sorry if this seems a daft question, ive never actually seen one in the flesh, so can only go off the pictures! Lol
Thanks in advance.
Darren

[neallewis]

Yeah regular servo plugs just push on to the pins. signal wire to outside, -ve to centre. The label shows you.

[Dazzle]

Nice one. Thanks for your reply. Was beginning to worry, the pics of it make it look like the gap between the pins is massive!!!! Lol