Shorty's for BMAX-2 MR ??

[Nige55]

Could do with some help and advice on shorty choice for my almost finished BMAX-2 MR, I've been trying to get some shorty's for it and a few I've tried (LRP and a cheaper voltz shorty) don't fit (without some serious grinding).
Would really appreciate a few options of ones that fit without modification.
I'm not looking for top end spec either, something around the 45-60 GBP mark.
Thanks in advance !
-Nige.

[discothesnake]

Are you talking straight up and down or across? I have tried both and had no issues with shortys fitting.

Orion and Reedy fit fine.

Dave

[mes]

The Vampire Racing shorty is a tight fit, but it fits without grinding.

[skyaflake]

I also needed to grind a little bit of material away when using a Gens Ace shorty. I'm going to try other shorties soon.

[Nige55]

Thanks for the replies & info guys, that helps a lot. I'm using them across the chassis, and It might be worth saying that I'm running the std plastic chassis (not sure if there is a difference compared to the alloy chassis battery tray). What dimension should fit across the car, would a 95mm shorty fit ? The Orions seem to be 95mm, and the LRP is 97mm (was told that is toooo big). Thanks again for the replies !

[Danosborne6661]

I've had a Turnigy Nano-tech across the width with no problems! (Plastic chassis also).

[big_boss]

Hi
I run Turnigy shorties length-ways (front to back) in rear motor with a big block of foam as a spacer in front of it. Never tried it side-ways though.

[bally]

These fit without any issues - http://www.rccarshop.co.uk/index.php/catalogsearch/result/?q=tp3800

Thanks
MB

[Nige55]

Thanks for the feedback guys. Looking at the sizes of the thunderpowers, it would mean that the HPI plazma shorty's should fit too. Does anyone know when they are available ?