Hobbywing Question Help Please

[bigtrev]

Help please i am running the xerun sct pro with a 5.5 four pole motor i have updated the firmware new sensor lead.

My problem is when i start a race there are no lights flashing on the speed controller but when i have finished the red and green flashing why ?????????

I have looked but all i can find is some said it is going from sensored to sensorless they are not hot tested that side of things as well.

Could it be the sensor board on the motor.

The power does drop a little bit but not much

Anyone any idea's i have also forgot i got two speed controllers both do the same thing

thanks

[beale]

Mine does it too if it goes sensorless you will notice it cogging at low speed, mine doesn't do that flaw or no flash, I think it's to do with neutral position as if it's slightly changed after a run?

[bigtrev]

Have you manged to stop it doing it then if so how. If it is that why is it doing it.

thanks