Can you post yout TM2 mansfield setup?

[Muzzie]

Guys,

I'm on a mission to figure out what is the best setup for the TM2 at Mansfield. After our outdoor outing on Sunday I can't believe there are load of us running TM2's all with different setups. Could you post your Mansfield setup?

Here's mine

Front

25 deg castor block
long link on the front camber link
Middle hole on the shock tower
outer hole on the wish bone
kit med springs
37.5 WT shock oil - kit piston, 2 holes drilled to 1.4mm
-0.5 camber
-0.5 toe out
Brass hop up
Front link on the Ackerman bar


Rear

Med link on rear camber inside hole
inside hole on the hub
Middle hole on shock tower
outer hole on the wish bone
kit med springs
-1.5 camer
30 WT shock oil - pistion 2 holes drilled to 1.4mm
5000wt diff oil

22t pinion
RW spur

7.5 motor

Side rails off

[dicky14]

Heres mine

25 deg caster block
long top link, no spacers
kit pistons drilled 2x 1.4 mm
37.5 wt oil
middle hole shock mount
outer hole wishbone
20gms weight over servo
kyosho 2wd front wheels
kit medium spring
19mm ride height
rear

short wheelbase
long toplink
kit pistons drilled 1.4mm x2
27.5wt oil
middle hole shock tower
outer hole wish bone
5k diff oil
delrin side rails
kit medium spring
20mm ride height

as already said 6 tm2s all set up different, lol:thumbsup:

[dicky14]

amendment to set up for indoors

front top link medium with 2mm spacer on inner ball
hard front spring to reduce tripoding
no side rails until grip came up.
1 deg neg camber
rear

alloy 02c rear hubs with medium length top link
2 deg neg camber
part worn yellow minipins
20gms rear chassis weight

car felt very lively but planted

[curtis538]

25 degree caster blocks
kit springs
37.5 shock oil
longest top link no spacer
kyosho front wheels
middle hole on shock tower
outer hole on wishbone
rear
kit springs
shortest top link
27.5 shock oil
kit springs
5k diff oil
kit side bars
hupo honigl dulsky speedo set-up
no dremeled top deck
:thumbsup::thumbsup::thumbsup: