MIP B4 drive shafts?

[MHeadling]

hi guys, i am looking at giving my b4 a mit of a re-vamp, i have most bits on it ray speed hubs, rpm bits,few k factory bits etc.

I fancy getting some chrome MIP cvd bones for it, my question is do I have to buy the MIP full drive shaft kit or can I buy the bones and fit them to my kit FT drive shafts? I have seen the bones on DMS websites part no MIP1551

[Mike Hudson]

there a direct fit to the axles no mods needed :thumbsup:

[ben]

If it was me i would replace the whole driveshafts because the axles, pins and other bits are probably worn so they will probably end up wearing the new bones out. ;) up to you:thumbsup:

[mattym0310]

I would say the same as ben. although the bones are a direct fit it wud be better to replace everything so that it's all new and unworn. PLus its better value for money! :)

[MHeadling]

Thanks for the replys guys, I have a spare set of new STD b4 drive shafts so I'll build these up with new bones. I know they won't make the car any faster but they will look pretty!