Mi1v2 - Servo won't fit?

[roobeats]

Hi all,

I have been building a mi1v2 and had some great help on this forum last time i was stuck so here I am again,

I have just been about to put the servo in but have noticed the arm on the steering bracket catches the top of the servo.

The manual is here

http://www.racing-cars.com/images/Technical_Info/Schumacher/Current%20Cars/Mi1v2/Instruction%20Manual/Mi1-V2_manual.pdf

I am on page 20

and the servo I have is low profile which is this one

http://www.modelsport.co.uk/alturn-usa-low-profile-servo-bb-mg-high-speed-/rc-car-products/359810

Hopefully its just something silly I am missing,

Thanks

[Mugenextreme]

Have u a picture showing your setup?

[roobeats]

Hi,

Yes i have attached some pictures to this message (i think)

hopefully that will show you what is catching (on the upper left of the servo)

Thanks again

[roobeats]

Still can't seem to figure this out, I assume all servos are the same size, the low profile ones, this was the one the store sold with the kit.

It just catches by a tiny bit.

Thanks

[Jesper$]

Some servos are a little thicker than others. I had the same problem and have bought a thinner servo, only because i needed fo another car also. Only thinner by 1 mm or so.
I have seen others mention that they put a 1mm spacer in the servosaver to lift the arm a little. Not sure exactly where they put it. It was on RcTech.net i read that.