View Full Version : Any pics of your 4WDs
Chris Larner
05-09-2015, 08:24 PM
Interested to see any pics and hear honest feedback about the build/quality and how it drives
leeboy44
06-09-2015, 06:14 PM
here is the photos of my car
the build was good few bits I'm not sure of like the thread on the shock shafts being minimal and the nut might un-wind and moulded pistons.
on the photo of the screws shows the only issues I had with the build
1 rear shock tower to shock screw was 3mm to short
and 1 front top link ball stud was 15.25 and should of been 17.5 I think
quick call to tony at serpent and they was in the post the same day!!
also bought a set of machined pistons
anyone wanting to build this car will need a 4.5mm nut driver witch was kinda frustrating
ive not had my lipos yet so the battery wires are long but apart from that its good to go :thumbsup:
Andy71
06-09-2015, 08:37 PM
I was marshalling a 4wd heat today at TORCH which contained an SX4 and I have to say from where I was it looked awesome.
The direction change and the way it stayed locked in through fast sweeping corners appeared to be very, very good.
This could be the car to tempt me back to 4wd!
The 12 hours of arendonk the car behaved well
There was a lot of grip available. Little too much but manageable.
Only seemed to frontarms was made of glass We have six broken. Two right and four left :bored:
So we dropped out at 11 o'clock (no A-arms more)
renjie
08-09-2015, 02:13 AM
anyone wanting to build this car will need a 4.5mm nut driver witch was kinda frustrating
I was caught out with this with my used SRX2 RM. Bought this one from HK
https://www.hobbyking.com/hobbyking/store/uh_viewItem.asp?idProduct=11463
Now if only my distributor will tell me he has my SRX4 in stock :(
feniks
11-09-2015, 08:16 PM
My car feels verre Nice on track and already love iT . Preferd THE shorty layout .
racingdwarf
11-09-2015, 09:35 PM
Bloody good grip by the looks of the photo!:p
feniks
12-09-2015, 05:38 PM
lol. made the photo with the ipad and than it always turns out wricht .
when i putted it up i noticed the problem :-).
still need a proper shel this whas just so i could hit the track .
http://www.petitrc.com/setup/serpent/setupsrx4/SRX4_JaredKirkwood_Build/18.jpg (http://www.petitrc.com/setup/serpent/setupsrx4/SRX4_ElectronicsSetups/)
MHeadling
12-09-2015, 06:06 PM
The king of wiring has struck again!
Great job Arno :thumbsup:
The king of wiring has struck again!
Great job Arno :thumbsup:
Not mine, Jared Kirkwood did ;)
muratti
14-09-2015, 08:49 AM
Mine with Tekin RSX esc and Tekin Redline Gen2 6.5t motor.
vBulletin® v3.8.7, Copyright ©2000-2024, vBulletin Solutions, Inc.