Bmax king pins

[DaveG28]

Finally getting round to fitting the champ pack king pins, and noticed while it all fits fine in the "low" position, in the high position there's loads of float in the steering spindle height? Has everyone else used 4mm washers to remove the float? Or is it not an issue?

[sosidge]

It's not going to be an issue. I started to fit some but for some reason it got a bit tight when I did, I think part of the castor block moulding is a close fit to where shims could go, so I took them off.

[DaveG28]

Good point, just looked and the same "float" is on my Bx, seems a bit odd but sod it, I'll give it a go at Worksop this week!