PR S1 V3 Steering Lock Issue?

[Bigdawgracer]

Hi All,

I've just bought an as-new V3 off here and put it together yesterday.

Looks to be a very well made piece of kit!

Possibly a stupid question but when I operate the steering I'm only getting half the steering lock I would expect? (It's the kit servo arm with an Expert micro servo)

The radio gear came straight out of my Serpent so I don't think it is a radio fault but too cold to check tonight.

Has anyone had similar issues?

Thanks for reading.

[K-Brewer]

Is the servo horn on maximum throw, if not adjust ur end points

[Bigdawgracer]

Hi thanks,

That was my next move!

Pivot ball is in the rear most hole on the centre steering arm by the way.

[Freakypen]

Hi- use the forward most hole on the servo saver arm and remove the rear hole. This will allow you to space the servo as far forward as possible which should sort it ;)