CORE-RC UDC20 WHAT LEAD ?

[stegger]

At present i'm using the UDC20 charger from Core-rc does anybody know what lead i need to charge orion,trakpower or lrp Lipo's ?
Part/no would be great:)

[super__dan]

Charge = ones in the box, balance = phone trakpower and they will tell you what lead you need.

[Adam Bailey]

Just cut one of the leads you aren't using and wire up the bullet connectors, or wire up a "Bullet" to "Deans" from the battery and use that

[muzzy]

Or even better go here: http://www.racing-cars.com/products.asp?recnumber=22576

New part just become available, so should make life sooo much easier for you, and will soon be in model shops :thumbsup:

[Cassp0nk]

Are the output connectors to the battery side of these chargers 4mm bullet sockets? They sell a nice cable set which would be handy with my bantam b6 if same plugs.

Also is this just a rebranded imax b6 as the form factor + menus + specs look really similar...

[stegger]

Cheers boys, mark you have a PM:)

[muzzy]

Got that Stegger, you have one back :p

Yes they are 4mm gold connectors on both ends of this lead, and one end has a Jst plug to go into your charger, like the Core, then the other end goes to a 2mm gold connector for balancing your lipo ie Speed Passion, Orion, Trak power etc.
Hope this helps.

[Cassp0nk]

Got that Stegger, you have one back :p

Yes they are 4mm gold connectors on both ends of this lead, and one end has a Jst plug to go into your charger, like the Core, then the other end goes to a 2mm gold connector for balancing your lipo ie Speed Passion, Orion, Trak power etc.
Hope this helps.

That really helps as core-rc sell the connecter set that comes with your charger for about 8 quid. Just what I need for my bantam b6 thanks :)

[martin]

The lead you need is from Schumacher PtNo CR056

Core Balance Charger Lead - JST to Trakpower etc

It has 4mm plugs both ends with a JST Balance connector for the charger on one end and a 2mm "spike" plug on the other for the battery.