KF2 Lipo post modification

[Jamie B4]

Hello all,

Just going to try and low profile lipo in my KF2 but just wondering if there is a way that I can modify my original posts so that I can run both low profile and normal lipos.

Anyone done anything in the way of this and what are the advantages of using lower lipo

Any advice please

J

[ianjoyner]

I just used some dense foam like this:

http://site.petitrc.com/setup/schumacher/setupcougarkf/KF2_MichalOrlowski_OCRC2016012124/Sat-OrlowskiKF2-6.jpg

A bigger piece would stay put without sticking it, so you could pull it out to put a full height in.

[Jamie B4]

Thanks Ian

[Ritchie T]

You can cut the posts down, theres still enough thread :thumbsup:

[tyreman]

I've got some you can have on Sunday Jamie.

[wingers]

I use the foam method as above.
If I want to run full size LIPOs then you just swap LH and RH and turn them upside down so the foam sticks up, not down :thumbsup:

Wingers

[Ralls Racing]

i drilled a 1.5mm hole at the correct height and use bodyclips to secure.

Nathan Ralls

[Jamie B4]

Thanks chaps for all your help - much appreciated