converting tc4 to buggy

[braddaz]

hi
has anyone converted an associated tc4 to a buggy :confused:
have got one in cuboard any fancy converting it
pics an info would be nice
thanks :)

[super__dan]

In an ironic twist BraddERS was involved in the version he and Neil Cragg ran for a while (was atually based on the TC3). Lots of people tried it but then the BJ4 came out and was miles better, since which AE (and HB) have since essentially used the same design as much more effective.

[Mike Hudson]

there was a conversion kit for a tc3 at one point but they wern't anywhere near as good as the jconcepts bj4 when it came out,

[jeroen206]

here is a converted tc3
http://www.overrc.com/courses/courses2005/cfhavre2005/cf2005havretc3o2.jpg

[dodgydiy]

i converted a tc3 once using b3 wishbones and a few other b3 bits and some carbon sheet for shock towers, actually went very well provided you ran the same width tyres all round

[Stu]

In an ironic twist BraddERS was involved in the version he and Neil Cragg ran for a while (was atually based on the TC3). Lots of people tried it but then the BJ4 came out and was miles better, since which AE (and HB) have since essentially used the same design as much more effective.

I think G has a 'Project CB' in his garage. I think.

[91notch5.0]

www.rcproductdesigns.com (http://www.rcproductdesigns.com)

tc3 conversion was very good in the right hands.

[jeroen206]

A TC-3 buggy conversion



http://cgi.ebay.com/TC3-0-BUGGY-b44-xxx-4-xx-lazer-zx-5-schumacher-cat-losi_W0QQitemZ150367116322QQcmdZViewItemQQptZRadio _Control_Vehicles?hash=item2302941c22&_trksid=p3286.c0.m14

[Holeshot]

This company use to do them - http://www.rcproductdesigns.com/ Not sure if they still do though