Novak SS5800 help plz

[kfcaddict]

I've just got a Novak SS 5800 and put it into my ZX-5. The problem im having is there is no response from either the servo or motor. All I have is a red and green light permanently on.

http://i2.photobucket.com/albums/y13/Peele/film003.jpg (http://i2.photobucket.com/albums/y13/Peele/film003.jpg)

The instructions say : Make sure input signal harness is plugged into throttle channel of receiver & ESC. Check throttle channel operation with a servo. Check wiring sequence of receiver signal harness. Green and Red status LEDs will both be on solid.

The gold connecter on the red to red is fine but the black seems like its a slightly different and won't fit properly but still makes a connection:

http://i2.photobucket.com/albums/y13/Peele/film006.jpg (http://i2.photobucket.com/albums/y13/Peele/film006.jpg)

Any help would be appreciated, thankyou

[kfcaddict]

If I hold down the reset switch for 5 seconds, all 4 LEDs light up, then they all flash 6 times. Then they individually light up in turn then it goes back to red and green perminant.