westie
04-05-2009, 05:38 PM
Hitec HS525MG Servo
Control System: +Pulse Width Control 1500usec Neutral
Required Pulse: 3-5 Volt Peak to Peak Square Wave
Operating Voltage: 4.8-6.0 Volts
Operating Temperature Range: -20 to +60 Degree C
Operating Speed (4.8V): 0.17sec/60° at no load
Operating Speed (6.0V): 0.13sec/60° at no load
Stall Torque (4.8V): 45.82 oz/in. (3.3kg.cm)
Stall Torque (6.0V): 56.93 oz/in. (4.1kg.cm)
Operating Angle: 45 Deg. one side pulse traveling 400usec
360 Modifiable: Yes
Direction: Clockwise/Pulse Traveling 1500 to 1900usec
Current Drain (4.8V): 8mA/idle and 250mA no load operating
Current Drain (6.0V): 8.7mA/idle and 280mA no load operating
Dead Band Width: 6usec
Motor Type: 5 Pole Ferrite
Potentiometer Drive: Indirect Drive
Bearing Type: Dual Ball Bearing
Gear Type: 3 Metal Gears 1 Resin Gear
Connector Wire Length: 11.81" (300mm)
Dimensions: 1.56" x 0.77"x 1.41" (39.8 x 19.8 x 36mm)
Weight: 1.78 oz. (51g)
£12 Posted :thumbsup:
Control System: +Pulse Width Control 1500usec Neutral
Required Pulse: 3-5 Volt Peak to Peak Square Wave
Operating Voltage: 4.8-6.0 Volts
Operating Temperature Range: -20 to +60 Degree C
Operating Speed (4.8V): 0.17sec/60° at no load
Operating Speed (6.0V): 0.13sec/60° at no load
Stall Torque (4.8V): 45.82 oz/in. (3.3kg.cm)
Stall Torque (6.0V): 56.93 oz/in. (4.1kg.cm)
Operating Angle: 45 Deg. one side pulse traveling 400usec
360 Modifiable: Yes
Direction: Clockwise/Pulse Traveling 1500 to 1900usec
Current Drain (4.8V): 8mA/idle and 250mA no load operating
Current Drain (6.0V): 8.7mA/idle and 280mA no load operating
Dead Band Width: 6usec
Motor Type: 5 Pole Ferrite
Potentiometer Drive: Indirect Drive
Bearing Type: Dual Ball Bearing
Gear Type: 3 Metal Gears 1 Resin Gear
Connector Wire Length: 11.81" (300mm)
Dimensions: 1.56" x 0.77"x 1.41" (39.8 x 19.8 x 36mm)
Weight: 1.78 oz. (51g)
£12 Posted :thumbsup: