LRP brushless reg with 3 cell lipo???? is it possible?

[kbenni]

Hello
can LRP A.I. Brushless Reverse Digital handle 3 cells of lipo with 9.5t motor?
where can i find something about it? somebody tryed it?
or som other lrp can handle 3 cels?

thx

Benni

[jono83]

Below in the technical specs of your speedo and according to themthe lowest brushless motor wind you could use is a 12.5 and the maximum voltage input is 9.6v so it not possible to use a 3cell lipo as the voltage out put is 11.1v

Special A.I. Brushless Features Waterproof
Fail Safe
Forward/Brake/Reverse
Sensored Design
Multi-Protection-System
Plug in and Drive
Limited-Lifetime-Warranty
Motorlimit Brushless: Over 12.5 turns
Motorlimit Brushed: Over 10 turns
Voltage Input: 4.8 - 9.6V
Type: http://www.rcmart.com/catalog/images/lrp_80150_004.gif

hth Jono

[kbenni]

i saw that but i somewhere saw car with this esc and wt 3 cells

[electric]

don't try it, the motor should be ok on 3s for a few "speed runs" but the esc will most probably pop when you plug it in
also just because someone else managed to do it with there esc it doesn't necesarily mean yours will work as i have found a few times :thumbdown:

[JJ The Boat Wizzard]

This May Or not help :

A Gm Brushless race spedo and motor can run upto 12v that would be your best bet if you were trying to run a 3 cell lipo :D