samd
16-06-2009, 06:53 PM
Not quite, but almost!!! Got this as a unfinished project, a HPI Pro4 one way, the crown wheel has been cut down to clear the pred x11 larger hinge pins.
The outdrives have been widened to take the pred bud ends on the drive shafts , but the driveshafts are just too long, about 1mm, so the outdrives need some more work to fit or as i did, space the ball joints out a bit at the hub.
Also has some schumacher outdives which are longer, the idea to use shorter rear driveshafts on the front, but they are just too short. Space the outdrives out a bit??
Diff is a straight fit into pred gearbox, just req about 1mm shimming as its slightly thinner then the pred diff.
My X11 08s gone so this is for sale as an unfinished project, also mentioned below!!
http://thepred.proboards.com/index.cgi?board=predatorX10&action=display&thread=434
Must be worth £10 posted!:D
http://g.imagehost.org/t/0564/16062009161.jpg (http://g.imagehost.org/view/0564/16062009161)
The outdrives have been widened to take the pred bud ends on the drive shafts , but the driveshafts are just too long, about 1mm, so the outdrives need some more work to fit or as i did, space the ball joints out a bit at the hub.
Also has some schumacher outdives which are longer, the idea to use shorter rear driveshafts on the front, but they are just too short. Space the outdrives out a bit??
Diff is a straight fit into pred gearbox, just req about 1mm shimming as its slightly thinner then the pred diff.
My X11 08s gone so this is for sale as an unfinished project, also mentioned below!!
http://thepred.proboards.com/index.cgi?board=predatorX10&action=display&thread=434
Must be worth £10 posted!:D
http://g.imagehost.org/t/0564/16062009161.jpg (http://g.imagehost.org/view/0564/16062009161)