mad rat moter mount, and help with brushless set up

[rc_dan]

built up my mad rat kit and the screws in the motor mount strip really really easly, any one else had this ? do thay replcae them, is there fault ?

also.. just ballraced it, any any one unsing a brushless set up in theres if so what motr you using, will a 6000kv plus 60amp esc be to much on 2sell lipo ?

will the stock pinion be a good starting point ?

regards dan

[jono83]

built up my mad rat kit and the screws in the motor mount strip really really easly, any one else had this ? do thay replcae them, is there fault ?

also.. just ballraced it, any any one unsing a brushless set up in theres if so what motr you using, will a 6000kv plus 60amp esc be to much on 2sell lipo ?

will the stock pinion be a good starting point ?

regards dan


This is a know fault some madrats were released with a faulty batch of motor plates contact ansmann for a replacement

[qatmix]

just get some 30mm threaded screws (button head, but preferablt small button like a hex fitting). screw them in from teh slipper side into some 3mm lock nuts.

I will post some pics in my build thread on my blog later today

[qatmix]

Ive added pics in my blog.

cheers

http://thercracer.blogspot.com/

[Battle_axe]

i was sent shake proof washers and nuts and bolts from ansmann to fix the problem

[qatmix]

nyloc nuts are just a bit easier to use

[Battle_axe]

nyloc nuts are just a bit easier to use
yer of corse they are i was just saying what they sent me