PDA

View Full Version : Schumacher wheel conversion to 12mm hex


Raul Garcia
28-07-2009, 01:19 AM
The are from New Era. Made for the Rascal, required some modification to fit but done none the less..

Funkymojo
27-08-2009, 10:23 AM
The are from New Era. Made for the Rascal, required some modification to fit but done none the less..

Looks good, so what modification did you do to get it to fit? Cheers

Raul Garcia
27-08-2009, 12:33 PM
Well first the Rascal spline is 10mm, and the CAT spline is 8mm. So, the spline had to be shaved down, I used a old outdrive part for the driveshaft, bolted it together, then lightly sanded with a flexible sanding disc on my dremel to fit inside the bearing to 8mm, then I had a machinist cut the hexes to be very narrow, because the track width is to wide with any aray of available wheel. I ended up using Kyosho SP (New style) rear wheel, and Kyosho 4wd SP 4wd front rim.

jeroen206
27-08-2009, 01:17 PM
http://www.racing-cars.com/forum/forum_posts.asp?TID=8508&PN=2



http://www.racing-cars.com/products.asp?recnumber=87
http://cgi.ebay.com/10x16-x5mm-Black-Rubber-Shield-Ball-Bearings-Savage_W0QQitemZ330351667089QQcmdZViewItemQQptZRad io_Control_Parts_Accessories?hash=item4cea7e6791&_trksid=p4634.c0.m14.l1262