View Full Version : Replacing throttle pot in 3VC
Northy
18-03-2007, 12:30 PM
Does anyone know anything about how to do this?
I have replaced the pot but have now got a dead spot on the throttle, is there a way of calibrating the pot to the tranny? :confused:
Anyone got a contact for David Bailey???
Cheers,
G
Northy
18-03-2007, 12:51 PM
I've just plugged a servo into the throttle output on the reciever and it has very very very little throw now, which I think is effectivly giving me the dead spot. Any ideas before I put the old pot back in? :(
G
gazbaz2
17-04-2007, 10:35 PM
I've just plugged a servo into the throttle output on the reciever and it has very very very little throw now, which I think is effectivly giving me the dead spot. Any ideas before I put the old pot back in? :(
G
Hi G
I had the same problem with mine, i just messed around with the throttle curve and that seemed to cure it, well it did for me anyway, hope this helps.
Gaz
vBulletin® v3.8.7, Copyright ©2000-2024, vBulletin Solutions, Inc.