PDA

View Full Version : To Glue or Not to Glue Tyres?


lucas-b4-b44
13-08-2009, 02:11 PM
On Xray T2'009:

I'm using my club control wheel/tyre setup of schumacher 20mm wheels/ 20mm mini pin tyres.

Do they need to be glued if using on indoor school hall type hard polished surface with 13.5 brushless?

Dazzler
13-08-2009, 02:27 PM
you sure do. To see what happens if you don't, mark the relative position of the wheels and tyres, then run a heat. See how the tyre moves on the rim. You may also get a tyre partially off a rim. When you do glue, you'll only need a couple of spots.

sosidge
13-08-2009, 03:10 PM
On Xray T2'009:

I'm using my club control wheel/tyre setup of schumacher 20mm wheels/ 20mm mini pin tyres.

Do they need to be glued if using on indoor school hall type hard polished surface with 13.5 brushless?

I ran those tyres a lot in the past and never glued them, never had one come off. This was using the blue inserts, I have seen the odd tyre come off using the soft white inserts.

lucas-b4-b44
17-08-2009, 01:11 PM
TY, for help: They seem perfect unglued :)

birdy b4
17-08-2009, 01:28 PM
they might be ok unglued , but if you hear your car making what i like to think sounds like a lightsaber from star wars noise when you go round corners then that is the tyre spinning round on the rim and they will probably need glueing

stox217
17-08-2009, 01:44 PM
Glue then you know they wont fall off in the race

lucas-b4-b44
17-08-2009, 02:50 PM
Ok, you guys have convinced me, I'm being lazy. I'll glue them :0

birdy b4
17-08-2009, 02:52 PM
:thumbsup: just use a few spots then if your tight like me you can re-use the rims :p

chris_dono
17-08-2009, 06:15 PM
there's no need to glue them with a 13.5 motor. If you're putting in a quicker motor, then maybe, but definitely not with a 13.5

bedsrcmcc
17-08-2009, 09:43 PM
Lucas, if you remember I was running unglued a few weeks ago and lost the A Final due to the rear coming off (inwards) causing the car to drive like a crab in the last few laps. I've since glued them now and no problem since, and that's running 13.5 in my 008 Xray.

I guess it depends how hard you are on the car. My minipins have only lasted 4-5 meetings, yet Cory's set still look good as new.

You might get away with it as the 009 is new to you, but I would suggest you glue them before the championship starts in 4 weeks.

Regards

Scott
www.bedsrcmcc.co.uk (http://www.bedsrcmcc.co.uk)