Split Pins/Roll Pins for 511/501x/DB01

[CraigM]

I found 2 threads on this topic but didn't find any part numbers nor could I locate the RW or Duratrax pins mentioned. Can someone point me in the right direction to find some suitable roll pins for the front and rear of my 511

Here are the 2 threads:
http://www.oople.com/forums/showthread.php?t=3107
http://www.oople.com/forums/showthread.php?t=3107

Cheers
Craig

[A.J. Gee]

I'm pretty much wondering the same thing. I can't drive my DB01 since my front hex adapters cracked. Does anyone know if there are any alternative adapters that i can replace with the original tamiya hexes? Thanks as always. :)

[AaronR]

AJ...

http://cgi.ebay.com/Tamiya-DB01-Aluminum-Front-Hex-Hub-Made-of-Tobee_W0QQitemZ350229041717QQcmdZViewItemQQptZRadi o_Control_Parts_Accessories?hash=item518b471235&_trksid=p4999.m20.l1116

[djmcnz]

AJ...

http://cgi.ebay.com/Tamiya-DB01-Aluminum-Front-Hex-Hub-Made-of-Tobee_W0QQitemZ350229041717QQcmdZViewItemQQptZRadi o_Control_Parts_Accessories?hash=item518b471235&_trksid=p4999.m20.l1116

Hi Aaron... will these fit a 511 as well?

[A.J. Gee]

Thanks Aaron. I hope those ones that are made by Tobee last longer than the Tamiya one's, although i had been running mine for a long while before they decided to crack. Those will work for the 501X to the guy above me. :thumbsup:

[AaronR]

Yep, those will work for DB01, 501X and 511s. I know what you mean, I have broken a couple sets of the orginal black ones. Good wheel nuts will help prevent those hexes from breaking.

The times that I did break them, I was tightening wheel nuts... slow tighten, slow tighten... CRACK! :mad: