what hex set ?

[rc_dan]

after a hex driver set, looked in the manual cant seem to find sizes.

does any on no what sizes i need ?

1.5 2.0 2.5 3.0 ?

[sparrow.2]

You will need a 2.0mm for most of the build and a 1.5mm for pinions. A 2.5mm will come in handy for motor screws and the like.

3.0mm is not needed for the Ansmann.

[rc_dan]

cheers mate :thumbsup:

[Paulmay79]

You will need a 2.0mm for most of the build and a 1.5mm for pinions. A 2.5mm will come in handy for motor screws and the like.

3.0mm is not needed for the Ansmann.


It is mate the cap heads that hold the motor on are 3mm.