PDA

View Full Version : Indoor motor


MatJohnson
03-10-2009, 02:49 PM
Need a bit of advice, whats gonna be a good BRUSHED motor for the winter at Os? Am thinking an 11x1 might be a little too much.

Mike Hudson
03-10-2009, 03:04 PM
I always liked 12 or 13t indoors back in the brushed days :thumbsup:

Welshy40
03-10-2009, 03:36 PM
I prefered a ten double. Down to what you prefer. Major torque use a ten, more of a relaxed accelaration and more top end use a 13d

Phil Channon
03-10-2009, 07:52 PM
Have you raced indoors at Oswestry before ?
If not, then its not that big and you can get upto 30 laps in the 6 min heat (depending upon track layout).
I run a 10.5 brushless with lipo and its quick enough.
I have run a 6.5 and spent most of the time trying to keep the car in a straight line. :lol:

MatJohnson
03-10-2009, 08:57 PM
Phil, Its been a while since I ran indoors, I assume its similar to how frodsham was back in the late 90's since that was when I ran indoors last.

Think for safety I will stick somit slower in, just until I have seen layouts grip etc.

Jonesy
04-10-2009, 01:12 PM
I'm looking forward to this on Thursday as I only have 7.5 slowest!!!!

Should be fun!

Big G
05-10-2009, 10:03 AM
what surface do you race on?

neiloliver
06-10-2009, 07:02 PM
Carpet, unless the moths have eaten it over the summer. With patches of old wooden floor where the carpet is not long enough.

jono83
06-10-2009, 07:12 PM
Me and ash will be at the club from about 11am to start tidying up indoor and try and get the rostrum up and the carpet down.

PaulRotheram
06-10-2009, 07:25 PM
When and how often do you guys race at oswestry? how many heats/rounds are there too?

jono83
06-10-2009, 08:21 PM
Every thursday night starting at about 7 we normally have 3-4 heats of about 6 or so cars

MatJohnson
07-10-2009, 08:10 PM
Anyone know someone who can skim me motors?

Big G
07-10-2009, 11:32 PM
I could, but I'm in Leominster (HR6)...

IceMike
08-10-2009, 07:21 AM
ill see if i can get someone to bring a lathe down for ya mate and ill do it for ya. just hope they still have the lathe handy at home, BRUSHLESS BABY!!!

ashleyb4
08-10-2009, 07:25 AM
I know adam has a lathe if you ask nicely im sure he could do it for you.

A

MatJohnson
08-10-2009, 07:46 AM
Cheers Mike, i've got a collection that needs doing :) should keep you busy tonight :)

Jamie B4
08-10-2009, 08:43 AM
Mike i've still got my lathe and checker so will bring it with me tonight

IceMike
08-10-2009, 10:15 AM
awesome J thanks :p ill have to go to the cash point for ya before i come down