PDA

View Full Version : Got to Go !


dayxwalker
29-11-2009, 05:53 PM
JR9000Z Servo Spec Below
Type: Ultra High Speed
Torque: 128 oz/in @ 6V
Speed: .06/60 degrees @ 6V (FAST AS YOU CAN GET)
Dimensions: 0.83x1.59x1.50 in
Weight: 2.2 oz
Gears: Metal Gears
22 +3 Delivery

x2 Hitec HS-5925 MG Servos
Control System: +Pulse Width Control 1500usec Neutral
Required Pulse: 3-5 Volt Peak to Peak Square Wave
Operating Voltage: 4.8-6.0 Volts
Operating Temperature Range: -20 to +60 Degree C
Operating Speed (4.8V): 0.10sec/60 at no load
Operating Speed (6.0V): 0.08sec/60 at no load
Stall Torque (4.8V): 102.76 oz/in. (7.4kg.cm)
Stall Torque (6.0V): 127.76 oz/in. (9.2kg.cm)
Operating Angle: 40 Deg. one side pulse traveling 400usec
360 Modifiable: Yes
Direction: Clockwise/Pulse Traveling 1500 to 1900usec
Current Drain (4.8V): 3mA/idle and 190mA no load operating
Current Drain (6.0V): 3mA/idle and 240mA no load operating
Dead Band Width: 1usec
Motor Type: Coreless
Potentiometer Drive: Indirect Drive
Bearing Type: Dual Ball Bearing
Gear Type: 3 Metal Gears, 1 Resin Gear
Connector Wire Length: 8.66" (220mm)
Dimensions: 1.55" x 0.78"x 1.48" (39.4 x 20 x 37.8mm)
Weight: 1.97oz (56g)
20 each + 3 Delivery

Xcelorin 4.5 like new
20+3 Delivery