cr2 set up for worksop ?

[ginger-racer]

Hi
has any one got a good set up for worksop for a cr2 ?

thanks Richard

[Northy]

This is what I ran at the BNWO - the car was fast but I didn't have much luck in 2wd :(


front:
Mini Pin Yellow
Green spring - 32,5wt - #56 - 1mm limiter
Middle wishbone
Outer tower
Camber link 3-B, 2 washers
10gr of lead in nose

rear:
Mini Pin Yellow
Red spring - 30wt - #56 - 0mm limiters
2 inside on tower
Inner on wishbone
Camber link 3-C, 3 washers
Wheel base medium
0° anti-squat

wing low, VLA front and rear long

Full lead piece under lipo
20g lead between lipos and motor
Lead under motor
Lead between back of motor and gearbox
-- try get the fr/rr weight split around 34/66

std CR rack no washers under ball studs

24/78 tooth on the 7.5


G

[Freakypen]

My car was pretty good also-though I made too many mistakes...

Front: 37.5wt oil, black spring, red ghea pistons, no limiters
Short VLA, middle camber link 1 washer,
Inside on caster block
Middle hole on wishbone, middle on a/c xd tower

Rear: Long wheelbase (safer) medium (Faster), 32.5 oil ghea red pistons, pink spring, no limiters
Long VLA,
Inside on top tower, middle on wishbone.
2nd hole out on top row camber link,
2nd hole out on middle of hub, 2 washers ( I think )
Std cr steering.
27/78 with Atomic idler mod, losi 7.5
Front wing / aurora rear wing.
2 deg anti/squat
Ghea fr bulkhead / Rudebits battery straps and under motor weight / lead under the battery approx 1850g.