ZX5 Slipper Measurement

[tc2k]

Would anyone be able to measure the length of the slipper shaft from the end where the bevel gear goes on to the risen ridge behind it?

[bert digler]

Would anyone be able to measure the length of the slipper shaft from the end where the bevel gear goes on to the risen ridge behind it?

yeah
:rolleyes:

[tc2k]

Well if anyones rebuilding a car it would be a simple thing to do. Very constructive to just come on and take the mick.

http://img.photobucket.com/albums/v492/thecrow2k/slipper.jpg

[KyoshoK]

why u need measurement for? i got a brand new one, if u need the measurement for a good reason i'll measure it for you

[tc2k]

Im looking to convert my Evo III to an offroad buggy and Ill hopefully use the ZX5 slipper and I need to see how itd fit and what Id need to modify.
EDIT: If you DO measure it, could you also measure the distance from the pin hole to the end. Thanks

[KyoshoK]

ok i'll get back to u

[tc2k]

Just wondered, did you get the measurement mate :)

[KyoshoK]

from start hole 6.6mm

from middle of pin hole to the end 7.35mm


width of hole is 1.5mm