View Full Version : wisebone binding
hi,
my front wishbones are binding badly and i dont want to go ahead an drill them out with a 3mm bit yet.
the hinge pins are 2.92mm so might be little slop as a result.
what have you guys done in this situation?
thanks
ian h
17-05-2010, 03:34 PM
The drill bit you want for this is actually 7/64 inches.
MiCk B.
17-05-2010, 03:38 PM
The drill bit you want for this is actually 7/64 inches.
Have a look at where it is binding.
Try just the front arms and see what it is like.
Are you running 30deg caster blocks, they're know to bind.
You'll need a 7/64" drill bit for the hinge pins on the B4, it will clean up the 30deg blocks make them free, with out getting slop into the suspension.
MiCk B. :-)
TomHow
17-05-2010, 03:54 PM
Hi Is this a new build as if it is I have the answer having been there this week :D
yeah it is the 30deg blocks, ordered some drill bits.
thanks for the helps. :D
vBulletin® v3.8.7, Copyright ©2000-2024, vBulletin Solutions, Inc.