Ve8 Build Help

[strugrat]

Hey guys,

Need help! Whilst assembling my car, and putting the front diff together, the M3 x18 bolts that go into the top of the spiral gear to seal the unit one of them has totally rounded off. Not sure why as it went in square but was so hard to tighten. By the time I realised it didnt feel right it was too late and I couldnt undo it or carry on tightening.

Dont particularly want to buy new bits as I've just bought the kit and to re purchase the front diff would be like £50! It's not leaking oil or anything but I dont particularly want to leave it like this.

Does anyone have any tips on how to get it out? Otherwise I'm off down the model shop tomorrow! I'm totally stuck and dont want to cause more damage.

Thanks
Ryan

[lgbzone]

Hi

You can probably get just a diff housing for a few quid

HTH

[dave g]

if you have a dremmel you can slot the end of the bolt and then use a screwdriver to undo it.

[jasonwipf]

if you have a dremmel you can slot the end of the bolt and then use a screwdriver to undo it.

Yep thats the best thing. very easy fix.

It shouldn't be "hard" to screw those in either, are you sure your not using the wrong size screw?

18mm seems a bit long, I think all of mine have always been m3 x 8 to 12.

Well good luck!