cougar drive shafts

[Aran]

hi guys,

thought maybe you could help me here, my drive shafts keeping out :( they are a few mm short.

i noticed drivers were using cat drive shafts which are longer, but is there another fix?

I going to try some small washers for now.

thanks

[Jamesy]

This shouldn't happen if you have built it up as per the manual.

Even if you wind out the rear shock ball cups 2 or 3 turns there shouldn't be enough droop for the driveshafts to fall out.

Did you use the short ball cup for the rear shocks?

What is the length of your rear shocks center to center?

What diff height did you build it with?

[bigred5765]

hi guys,

thought maybe you could help me here, my drive shafts keeping out :( they are a few mm short.

i noticed drivers were using cat drive shafts which are longer, but is there another fix?

I going to try some small washers for now.

thanks
if thats happening aran you have to much droop mate you want to measure over all shock length from very top to very bottom and it should be no more than 95.5mm

[Aran]

everything is as instructions.

the diff is low.

it only seemed to be on this one jump on the main straight (not the best place to break down)

ill check the shocks

[moth898]

Do you have the arms installed in the right direction?

[Aran]

yep everything is right, except some reason both front and rear were out by 4mm :S.

i reckon i may of got the calliper tool wrong, just strange how it was both lol, noob night tonight.

thanks! :D