Core UAC-40 help needed please !!!!!!!

[RDG 40]

Just getting used to my charger above.

Can someone please help me with the following two questions:

-What is difference between charge function and fast charge function, and does it damage LIPO's in anyway or reduce life either one?

-Storage mode how do you set it. I know how to get to it but it only goes to 1.0 as apposed to say my 5000 packs that i charge at 5.0. What should i be doing to make sure the LIPO stores correctly with this function.

The instructions are pants tbh and im very keen not to naker my new LIPO's

I run some 5000 50c and some 4200 35c for clarification.

thanks in advance

Russ

[/tobys]

unless you are not planning on using your lipos for quite some time (several weeks), you shouldn't need to use storage mode. in-between meets (e.g. 1-2 weeks), lipos should be quite happy to sit there partially charged.

[RDG 40]

it could be quite a few week hence the need for storage

[/tobys]

are you able to adjust the charge rate in Storage mode? I believe it just charges/discharges to a particular voltage...

[RDG 40]

in storage it has the ability to change from 0.1 - 1.0

[/tobys]

when I did it, I just run through the storage mode after my regular lipo use and it was fine.

that was on a "clone" of the predecessor, UAC-30, mind you but suspect it's mostly the same software on-board...