rowanp25
03-08-2010, 03:55 PM
well its not really vintage but with advances in technology in the sport its prehistoric.
ive decided i just dont have the time so here goes,
i have a predator p8 with ballraced steering and rockers, ive drilled out the two rear holes that hold the rear gearbox in place so i could use nylock nuts to hold it together, also modded the front pushrods to the x11 shorter mountings. theres a tonne of spares including transmission, bearings wishbones and a spare chassis with cell slots cut out.
theres a couple of brushed 10x2 motors with a few skims left but could do with new brushes.
theres a nosram dominator evo in the car plus a novak xxl receiver and scanner ssv9766 servo.
lrp pulsar charger with 10 amp power supply
sanwa gemini 2 radio with original charger and 2 sets of crystals (no 311 receiver though
2 sets of cells, 1x intelect 4200 and a set of lrp sport 3600s both hold a charge and are raceable theres also a set of gp 3300s that need assembly but did run well before they were disassembled.
lrp diamond tipped comm lathe with all original hardware and hard case (no 4 cell pack though but runs fine off the pulsar)
i would prefer to let it go as a job lot for say £250 plus postage via your choice of delivery or collection is fine if your north of the border.
Oh pics available on request for any interested party
http://i244.photobucket.com/albums/gg37/rowanp25/perd.jpg
ive decided i just dont have the time so here goes,
i have a predator p8 with ballraced steering and rockers, ive drilled out the two rear holes that hold the rear gearbox in place so i could use nylock nuts to hold it together, also modded the front pushrods to the x11 shorter mountings. theres a tonne of spares including transmission, bearings wishbones and a spare chassis with cell slots cut out.
theres a couple of brushed 10x2 motors with a few skims left but could do with new brushes.
theres a nosram dominator evo in the car plus a novak xxl receiver and scanner ssv9766 servo.
lrp pulsar charger with 10 amp power supply
sanwa gemini 2 radio with original charger and 2 sets of crystals (no 311 receiver though
2 sets of cells, 1x intelect 4200 and a set of lrp sport 3600s both hold a charge and are raceable theres also a set of gp 3300s that need assembly but did run well before they were disassembled.
lrp diamond tipped comm lathe with all original hardware and hard case (no 4 cell pack though but runs fine off the pulsar)
i would prefer to let it go as a job lot for say £250 plus postage via your choice of delivery or collection is fine if your north of the border.
Oh pics available on request for any interested party
http://i244.photobucket.com/albums/gg37/rowanp25/perd.jpg