ansmann vapor

[davidmog99]

Anybody race one of these? Any info on any weak points, essential hop ups?
Running on 3 cell 3000kv motor and seems quick enough. Will it take four cell?
Any help welcome, theres not a lot of info about. Thanks

[jasonwipf]

4cell with that motor would be over kill on speed assuming the esc could even handle it.

[davidmog99]

Can i increase duration by using two 3 cell packs wired differently?
I am intending to race it.

[jasonwipf]

Yes, run in serial it would double the MAH rating in parallel it would double the voltage (dont do that, if your ESC is not rated for 6 cell it will burn it up and with even if it could that much voltage on a 3000kv motor will have your car doing back flips on the starting line, hehe). Check with your local hobby shop for the plugs, you could make them too.

[SLEENAD]

uhhm, serial doubles the volts and paralal the amps thus runtime!

[johnnygibbon]

reckon you be ok on 4 cell but watch out trying 6 it will probly fry it .get lrp or mamba/flux for 6 cell insanity power.
whats this car like any way .is it ok
is it copied of any more established 8ths

[Timee80]

I think the standard esc can only handle 3s. I wouldnt try 4s.

[losi madness]

if you want to run 4s you will need a hpi flux or a mamba tekin rx8

[davidmog99]

The car seems ok, but only run it for a couple of minutes before the servo horn broke.
Dont know what its a copy of. Anyone?
Has good speed on 3 cell!:thumbsup: