PDA

View Full Version : Hello, hoping to get down to race.


S.A.W
02-11-2010, 09:42 PM
Hi,

Just ordered a B4.1 Team and hoping to get down soon once the track is sorted and I've got my buggy ready.

I currently race TC at Aldershot and Newbury which I see a few people from there at Torch a couple of weeks ago.

I'm probably going to run SP, just wondered what turn motor I'll need and a rough fdr ?

Also what tyres, can I get them with wheels pre glued etc, if so does anyone have a link to them ?

Oh and any particular servo ?

Thanks.

Simon.

mikeyscott
02-11-2010, 09:48 PM
Hi,

Motor I'd go for a Speed Passion 8.5 or 7.5
Servo Savox 1258 or 1257

Schumacher mni spikes - compound prob yellow, but not sure until track is laiid

Schumacher staggered ribs or mini spikes on the front - yellow - dependent on set-up

wet running
Ballistic buggy pink mini spikes or green - rear
Schumacher green mini spikes - front



Mike

simoncrabb
02-11-2010, 10:45 PM
Off road tyres tend not to be pre-glued. It's all about DIY and supergluing your thumbs to them! It's ace fun!

S.A.W
02-11-2010, 10:54 PM
Hi,

Motor I'd go for a Speed Passion 8.5 or 7.5
Servo Savox 1258 or 1257

Schumacher mni spikes - compound prob yellow, but not sure until track is laiid

Schumacher staggered ribs or mini spikes on the front - yellow - dependent on set-up

wet running
Ballistic buggy pink mini spikes or green - rear
Schumacher green mini spikes - front



Mike

These ok,

http://www.modelsport.co.uk/?CallFunction=ShowSpecification&ItemID=31053

http://www.modelsport.co.uk/?CallFunction=ShowSpecification&ItemID=31054

S.A.W
09-11-2010, 01:58 PM
Hi,

So these for the rear http://www.jespares.com/electric-models?page=shop.product_details&flypage=flypage.tpl&product_id=7191&category_id=1180

and for the front these http://www.jespares.com/electric-models?page=shop.product_details&flypage=flypage.tpl&product_id=6842&category_id=1180 or these http://www.jespares.com/electric-models?page=shop.product_details&flypage=flypage.tpl&product_id=7368&category_id=1180

what insert's do I need or shall I just use the one's that came with the B4.1 kit :confused: