48dp pinion with a .5 spur

[FERRETTI]

I have been told that a 48dp pinion will work fine with a metric Tamiya .5 spur, please can someone advise me if this is correct:confused:

thanks.

[jimmy]

it will work yes - but it's certainly not ideal and will be noisy. I think the first few runs it will take some material off the spur also.
You might be able to get a 48dp spur for the original car, but I found an easy way was to get the tamiya slipper kit - and an associated B4 spur / slipper pads. I think the B4 81 tooth spur is a larger diameter than the 82tooth kit spur - so that gives you an idea of the different sizes. 81t 48dp spur also needs the gear cover sanding inside to fit the slightly-too-large diameter.

[FERRETTI]

Is that modification for the Keen Hawk chassis models? will it also work for the TTC?

[jimmy]

oops, sorry - I don't even know what a TTC is? The only car I've experience with .5 module is the DF03 yes - I don't know about others so ignore the suggestion I made about slipper etc.. :wtf:

[FERRETTI]

Sorry Jimmy I should have been clearer, the TTC (Tamiya Traction Control) is the Super Astute transmission with slipper, it also uses .5 pitch.

Does anyone know where I might get some .5 pinions?

[BelstenToo]

I got mine off ebay

[FERRETTI]

I got mine off ebay

not a lot of help, but thanks anyway.

[BelstenToo]

Why wasn't that a lot of help?
Here try this then.

http://search.ebay.co.uk/search/search.dll?sofocus=so&sbrftog=1&catref=C6&from=R10&_trksid=m37&satitle=df-03+pinion&sacat=-1%26catref%3DC6&floc=1&sargn=-1%26saslc%3D2&sadis=200&fpos=NP26+3JH&sabfmts=1&ga10244=10425&ftrt=1&ftrv=1&sabdlo=&sabdhi=&saprclo=&saprchi=&fsop=1&fsoo=1

[FERRETTI]

Sorry BelstenToo,

my response was a bit curt:( (one too many shandies last night:rolleyes:), what I should have said was I've checked Ebay and there isn't a lot of choice only down to 23t and I think I might need to go to 16/17t.

Thanks.