lipo problems

[purplenut]

Ok i for some reason can not get the long body clip through when putting the lipos in?.
Lipos are lrp 5000 go them upside down its close but not enough.
What am i doing wrong???
Thanks

[captainlip]

wont go through the last part, i had this problem for hours after i cut 1cm off the clip and no in everytime no issues.

[purplenut]

wont go through the last part, i had this problem for hours after i cut 1cm off the clip and no in everytime no issues.
No i can not even get it through the first part???

[steve73]

A little bit too high with 25,1 mm?

[purplenut]

A little bit too high with 25,1 mm?
But iam sure i asked months ago if these would fit and the answer wa yes???

[hide]

I had this problem. Make sure that you have the hinge on the rear diff on the upper setting and they should fit fine.

[steve73]

But iam sure i asked months ago if these would fit and the answer wa yes???

OK, i only know the original Report and it says 25 mm: http://www.team-durango.com/blog/?p=1175

[TonyM]

I had this problem. Make sure that you have the hinge on the rear diff on the upper setting and they should fit fine.
Same here, once I moved to the upper setting my 5000 50C LRP's fit fine.

[Mike Parker]

Ok i for some reason can not get the long body clip through when putting the lipos in?.
Lipos are lrp 5000 go them upside down its close but not enough.
What am i doing wrong???
Thanks

I'm running GM's and found the same problem. I've put 1mm washers underneath the front mount to raise it slightly and all's good. Hope this helps :)

[purplenut]

I'm running GM's and found the same problem. I've put 1mm washers underneath the front mount to raise it slightly and all's good. Hope this helps :)

Funny enough I was going to try that tonight cheers

[muratti]

Can it be that you´ve got the same problem like the guys in this thread:

http://www.oople.com/forums/showthread.php?t=58264

[hide]

I know for a fact the LRP 5000mah 50C packs fit. Check out the thread Muratti posted.

[Big G]

I'm running GM's and found the same problem. I've put 1mm washers underneath the front mount to raise it slightly and all's good. Hope this helps :)

exactly what I did. no problem now :)

[purplenut]

Can it be that you´ve got the same problem like the guys in this thread:

http://www.oople.com/forums/showthread.php?t=58264
Yep Sorted it now tho and electricts were fun to pics going on now(in show me yr)
Leon