Nosram Matrix 2007

[Billy]

Any ideas how to fix back on my speedo the metallic plate with the Nosram logo on, the one that covers the speedo from the top side!

I pulled out the heatsink and came of with the plate together. I've cleaned the old conductive paste, but I cannot find a suitable conductive - adhesive paste, only permanent ones, which if I need to open the speedo for cleaning sometime I don't think that it will ever come off.

I've emailed Nosram also about this issue and guess what, I did not get any reply as if we will steal their big secrets! As usual never get a response from Nosram, I don't know why although their products are very good....

Should I use Arctic Silver conductive paste, but it is not adhesive and then how can I keep the plate on the speedo?

Many thanx in advance!

[Richard Lowe]

If you only use paste it will fall off, though TBH I think thats all they use at the factory :rolleyes:

The tops falling off is a common thing with the Sphere/Matrix, I've glued mine back on with Arctic Silver adhesive (Alumina I think) but it's never coming off again...
I think about half the north-east has 'borrowed' the adhesive to hold the tops on their ESC's :wtf:

[mark christopher]

mirage told me to put white paste on the heatsink/fets then run super glue round the case edge and heat sink.
did that and mine never mover even with the fan on

[Billy]

Thanks guys! I think these are the two options to go. Nice!