changing sero plugs

[reg]

Hi,i need to change the plugs on my savox servo and lrp speedo,they have seen better days,they dont fit very well and there is wire showing,can someone let me know what is needed and what tools,if possible any hint and tips for the best way to do it,
thanks

[ch!3f]

best way to replace them is to get some new wires(couple of these) (http://cgi.ebay.co.uk/300mm-Futaba-Servo-Extension-Lead-/120679115971?pt=UK_ToysGames_RadioControlled_JN&hash=item1c19092cc3#ht_500wt_949) cut the unneeded end off and solder them on the circuit boards on the esc and servo done a few of mine just use a narrow tip soldering iron.

doing this you can make the wires the lengths you want them and they dont look a mess in your car

[steelie600]

You can buy the ends and just crimp new terminals on and use new plastics!! DAMN sight easier than soldering to the board!

[reg]

thanks ch!3f,but me and soldering dont go:blush:......steelie600 i think that is the way ill go,any ideas were to get the crimping tool from?