Camber

[adam_111]

Hi guys,

im new to off road and i was just wondering, when i set the camber on a mad monkey, do i push the car down and set the camber from where it rebounds to?

cheers :)

[adam_111]

ive just checked out the camber that the manual says to dial in, and its seems rather alot too much, anyone got any opinions on this?:S

[Robbiejuk]

Hi guys,

im new to off road and i was just wondering, when i set the camber on a mad monkey, do i push the car down and set the camber from where it rebounds to?

cheers :)

Yeah load up the car with all relevant radio gear, motor and battery. Find a nice flat surface and drop the car from about a foot onto it. let the car settle and then take your readings.

A good starter point is 1 degree all round I find.

Can't comment on the mad monkey kit setup as I haven't got one but I would say go for 1 degree all round to start off with and then change to your likgin after driving.

[Cameo]

Hi guys,

im new to off road and i was just wondering, when i set the camber on a mad monkey, do i push the car down and set the camber from where it rebounds to?

cheers :)

Yes, the camber needs to be set in acordance with the ride height.
I use 0 deg on the front and 1 deg on the rear. If you need a little more steering or quicker response then change the front to 1 deg.

[adam_111]

cheers guys! all setup now :)